User Manual
29D-Link DCS-2530L User Manual
Section 3: Conguration
Enable UPnP
Presentation:
Enable UPnP Port
Forwarding:
Enable PPPoE:
User Name /
Password:
HTTP Port:
Access Name for
Stream 1~3:
HTTPS Port:
RTSP Port:
Enable CoS:
Enabling this setting allows your camera to be congured as a UPnP
device on your network.
Enabling this setting allows the camera to add port forwarding entries
into the router automatically on a UPnP capable network.
Enable this setting if your network uses PPPoE.
Enter the username and password for your PPPoE account. Re-enter your
password in the Conrm Password eld. You may obtain this information
from your ISP.
Enter the port to use for HTTP access to the camera. The default port
number is 80.
Enter a name to use for HTTP streaming access. The default name is
video#.mjpeg, where # is the number of the stream.
Enter the port to use for HTTPS access to the camera. You may use a PC
with a secure browser to connect to the HTTPS port of the camera. The
default port number is 443.
Enter the port number to use for RTSP streaming to mobile devices.
The default port number is 554. You may specify the address of
a particular stream. For instance, live1.sdp can be accessed at
rtsp://x.x.x.x/live1.sdp where the x.x.x.x represents the IP address of your
camera.
Enabling CoS allows you to specify the Class of Service for dierent types
of trac so you can prioritize their transmission on your network. CoS
helps provide prioritization for Layer 2 trac.