User manual

10D-Link DCS-1110 User Manual
Section 2 - Installation
Hardware Installation
Attach the External Power Supply
Attach the external power supply to the DC power input connector located on the rear panel of the DCS-1110 and
connect it to your local power supply. Note: Power source is confirmed when the blue LED Power Indicator located to
the right of the lens on the DCS-1110 is illuminated.
Connect the Ethernet Cable
Connect the included Ethernet cable to the network cable connector located on the back panel of the DCS-1110 and
attach it to the network. Network Connectivity is confirmed when the orange LED Indicator on the DCS-1110 located
left of the Power LED is illuminated.
Note: The power supply is optional if the
PoE (Power over Ethernet) is used.