User's Manual

Ethernet Cable

Connector

DC Power

Connector

I/O Connector

Antenna Connector

Slide Switch

Reset Button

Antenna Connector

Rear Panel

Network Cable Connector

The DCS-1000W’ s rear panel features an RJ-45 connector for connections to

10Base-T Ethernet cabling or 100Base-TX Fast Ethernet cabling (which

should be Category 5 twisted-pair cable). The port supports the NWay

protocol, allowing DCS-1000W to automatically detect or negotiate the

transmission speed of the network.

DC Power Connector

The DC power input connector is located on the DCS-1000W’ s rear panel and

is labeled DC 5V with a single jack socket to supply power to DCS-1000W.

Reset Button

Reset will be initiated when the reset button is pressed once and Power LED

begins to flash.

Factory Reset will be initiated when the reset button is pressed continuously

for three seconds or when Power LED begins to light up. Release the reset

button and the Power LED will begin to flash indicating that the DCS-

1000W’ s settings are reverting back to the factory settings. When factory reset

is completed DCS-1000W will be set to default on channel 11 and EES-ID is

set as “NULL String” (This default setting will let DCS-1000W connect to

ANY access point on the infrastructure network). The IP address will also

return to the default setting as 192.168.0.20.