Specifications

13D-Link DCM-202 User Manual
Section 2 - Installation
Connecting the Cable Modem
Install the cable modem according to the following procedure:
1. Power off the computer.
2. Unplug the computer from the electrical wall outlet.
3. Make these connections:
• Connect the coaxial cable to the cable modem’s CATV cable connector. If you plan to have the cable connected
to a television as well as the cable modem, you must use a cable line splitter (not included).
• Plug the cable modem’s power adapter into a wall outlet or surge protector and into the cable modem’s
power jack.
• Plug one end of the Ethernet cable into the cable modem’s Ethernet port and the other end of the cable into
the existing NIC.
4. Plug in the computer.
5. Power on the computer. When installation is complete, your setup should resemble the illustration above. The
modem is operating properly if the Power, Cable, Status and ETH light emitting diodes (LEDs) are solid green
(lit and not blinking).