User Manual

Chapter 4 Configuration Page 28
Base Station ID
The SSID is a unique identifier that bridges use to associate to each other. It is case-sensitive
and consists of no more than 32 alphanumeric characters. By default, it is set to “
Wireless”.
Output Power
If the bridges are installed less than 328ft (100m) apart, the output power should be adjusted
lower to avoid overloading the bridge’s receivers.
To configure the output power, open “
Radio” and select the appropriate output power value:
Full, Half, and Quarter.
Channel/Frequency
Channel varies much as the available band differs from country to country. Select a proper
operating channel in the drop-down list according to your situation.
Advanced Settings
After basic settings, you might need to configure some parameters to optimize performance or
enhance your network security.
Super Mode
The super mode is designed to enhance throughput by decreasing data waiting time slot.
Open “
Radio” and check “Fast Frame”, “Burst’ or “Compression” box accordingly.
Security Settings
Security settings are effective to prevent unauthorized access to your network. It supports
open system, shared key, WPA-PSK, WPA2-PSK and WPA-PSK&WPA2-PSK. To enable
security, open “
Security” page as below: