User Manual

Chapter 3 Hardware Installation Page 20

2. Plug a user-supplied Cat-5 Ethernet cable from the DAP-3760 / DAP-3860 into the

power injector RJ-45 jack (

P+DATA OUT);

3. Connect the power module to the power injector and plug the AC cord into an AC power

receptacle;

4. After being powered on, the device will send out the beep sound lasting about 1.5

seconds, informing you that the DAP-3760 / DAP-3860 is powered up! Wait for about

60 seconds the system will be initialized and start working.

Make sure PoE is correctly connected to the RJ-45 port on the DAP-3760 /

DAP-3860 labeled PoE+Data, otherwise the extender will be severely

damaged!

Warning: