Installation guide

DAP-1650
6
ENGLISH
TROUBLESHOOTING
SETUP AND CONFIGURATION PROBLEMS
1. HOW DO I CONFIGURE MY DAP-1650 AP WITHOUT THE CD, OR CHECK MY WIRELESS
NETWORK NAME (SSID) AND WIRELESS ENCRYPTION KEY?
- Connect your PC to the range extender using an Ethernet cable.
- Open a web browser and enter the address http://dlinkap.local or http://192.168.0.50
- The default username is ‘Admin’. The default password is blank (leave the eld blank).
- If you have changed the password and can not remember it, you will need to reset the AP to
revert the password back to blank (leave the eld blank).
2. HOW DO I RESET MY DAP-1650 AP TO FACTORY DEFAULT SETTINGS?
- Ensure the range extender is powered on.
- Press and hold the reset button on the rear of the device for 5 seconds.
Note: Resetting the range extender to factory default will erase the current conguration
settings. To re-congure your settings, log into the range extender as outlined in question 1, then
run the Setup Wizard.
3. HOW DO I ADD A NEW WIRELESS CLIENT OR PC IF I HAVE FORGOTTEN MY
WIRELESS NETWORK NAME (SSID) OR WIRELESS ENCRYPTION KEY?
- For every PC that needs to connect to the range extender wirelessly, you will need to ensure
you use the correct Wireless Network Name (SSID) and encryption key.
- Use the web based user interface (as described in question 1 above) to check or choose your
wireless settings.
- Make sure you write down these settings so that you can enter them into each wirelessly
connected client. You will nd a dedicated area on the back of this document, this important
information for future use.