Installation guide

DAP-1650
4
ENGLISH
SET UP DAP-1650 USING Wi-Fi PROTECTED SETUP (WPS)
NOTE:
To extend the Wi-Fi network in your home using the DAP-1650 WPS feature
please make sure the source router or AP also features WPS.
NOTE:
The DAP-1650 can be further congured using the web GUI. After you have plugged
the DAP-1650 into a wall outlet and the power LED is solid green, go to the wireless
utility on your computer, select the DAP-1650 network, and enter the password (this
is on your Wi-Fi Conguration Card). Then open a web browser and type
http://dlinkap.local. By default, the username is Admin, and the password eld
should be left blank. Please refer to the product manual for further information on
conguring the DAP-1650 using the web GUI.
PRODUCT SETUP
WPS SETUP
Next, push the WPS button on the DAP-1650. The LED will start to
ash green.
Please allow up to two minutes for the process to nish.
The DAP-1650 is now ready to share the extended
Wi-Fi network with your PCs and mobile devices. Connect to the
DAP-1650 using the network name (SSID) and password printed
on your Wi-Fi Conguration Card.
Plug the DAP-1650 into a wall outlet and wait until the power LED is
solid green. Push the WPS button on the source wireless router or
AP.
The power LED will turn solid green when the DAP-1650 has
connected successfully to the source wireless router or AP.