User Manual
13D-Link DAP-1620 User Manual
Section 3 - Conguration
WPS-PBC Conguration
Step 1 - Initiate WPS Mode
While the Status/WPS LED is blinking amber, push the WPS button on the source
wireless router or AP, and then push the WPS button on the DAP-1620. The Status/
WPS LED will start to ash green. Please allow up to two minutes for the process to
nish. The Status/WPS LED will turn solid green when the DAP-1620 has connected
successfully to the source wireless router or access point.
Step 2 - Assess Result
If the Signal Indicator LED has a single amber bar after the connection process has
nished, the DAP-1620 has established a poor quality connection. To improve the
connection quality, move the extender to a wall outlet closer to the source wireless
router or access point. The more lit bars on the Signal Indicator LED, the better the
wireless signal.
Step 3 - Connecting Devices to the DAP-1620
The DAP-1620 is now ready to share the extended Wi-Fi network with your PCs and
mobile devices. You may use the WPS method to connect devices to the extension
networks created by the DAP-1620 using the following network names (SSID). The
password(s) will be the same as the wireless network you are extending.
• 2.4 GHz: (Your router’s SSID)-EXT
• 5 GHz: (Your router’s SSID)-EXT5G
Using the 5 GHz extension network is recommended in order to achieve the fastest
wireless speeds.
To connect to a wireless router or access point and extend the Wi-Fi network in your home, rst make sure the source router or Access
Point features a WPS Button or has a virtual WPS Button.
Very Poor
Connection
Poor
Connection
Good
Connection
Best
Connection