User Manual

DAP-1610 Install Guide 5
4
When the Status LED turns solid green (may take up to 3 minutes), this indicates
that your Range Extender is connected to your wireless router. You can now
unplug and move your Range Extender to a location between your wireless
router and the area where you want wireless coverage.
Note: If the Status LED on your Range Extender does not turn solid green
after running WPS setup, try resetting the unit (see Troubleshooting - What
if I forgot my Range Extender’s Admin password or want to reset my Range
Extender?) and try WPS setup again. If it still does not turn solid green after
following all the steps, see Method Two: QRS Mobile Setup, on page 6.
Your setup is complete! To connect your wireless devices to your Range Extender,
see Connect Your Wireless Devices, on page 7.
If after moving your Range Extender, the signal
strength indicator is showing one single amber bar or
if your Range Extender LED does not turn solid green
within 3 minutes, move your Range Extender to a wall
outlet closer to your wireless router.
Signal Strength Indicator
Very Weak (1 x Amber)
Weak (1 x Green)
Good (2 x Green)
Strong (3 x Green)