Specifications

1.5 FUN Functions
1.5.1 In and out of FUN functions
○ ：Indicates when multiple DAPs are connected, the information set by one of them is not available for use until PLC is reset.
＊：Indicates when multiple DAPs are connected, each DAP can be set respectively.
■ Exit of FUN functions to general data access functions. Press ＋ ＋ ＋
20、LOCK R/W ID
CODE OF RF CARD
19
、WRITE RF CARD
17
、DAP ASSIGN.
FOR 8/16-KEY
18
、SELECT ID
CODE OF RF CARD
1
、PASSWORD OPEN
2
、PASSWORD CLOSE
4
、DEFINE FUN KEY
3
、PASSWORD SET
5
、DEFINE ALARM
ADDRESS
6
、DEFINE SOFTKEY
(8-KEY)
8
、DEFINE SOFTKEY
(16-KEY)
7
、ENTER SOFTKEY
MODE (8-KEY)
9
、ENTER SOFTKEY
MODE(16-KEY)
12
、MAX. DAP NO.
ON NETWORK(1~16)
15
、RF CARD
START ADDR.
14
、RF CARD MODE
13
、WRITE PROTECT
16
、ENABLE
KEYS MAPPING
＊
＊
＊
○
＊
○
○
○
○
＊
○
10、VOLUME
11
、SET DAP NO.
+
■
Enter FUN functions
Press
＊
OR
+
Monitored items
(Lock the ID code of RF card)
(Write new ID code into RF card)
(Select the ID code category of RF card)
(8/16 soft keys mode assignment for each DAP )
(Enable keys mapping to corresponding special contacts)
(Set the start address to store the ID code of RF card)
(Set the max. DAP numbers
(1-16) on network for multi-link)
(Set DAP NO. for multi-link)
(Enter the 16 soft keys mode)
(RF card mode selection)
(Data write-in protection)
(Adjust volume)
(Self-defined 16 soft keys)
(Enter the 8 soft keys mode)
(Define the start address of content for display at an alarm)
(Self-defined function keys for fast monitoring)
(Self-defined 8 soft keys)
(Password setting)
(Password blocked)
(Password open)
Note：1、When several DAPs are connected, information can be stored to PLC (D2944～D3071) if one of the DAP is set in
all the FUN functions (except item 11).
2、After entering FUN 4~20, without password protection, all the FUN functions can be executed by only pressing
. With password protection, it is required to pass it first before executing FUN functions.
3、If it is password-protected, FBs-DAP will be set in a password protection status at each beginning of operation.
4、FUN items 1~9 can be entered with numeric keys directly and then go straight to that function.
5、After executing a item of FUN functions, if execution of other items is required, press the three keys
+ + again.
Appendix I -5