User manual

53D-Link DAP-1360 User Manual
Section 3 - Configuration
LAN Connection Type:
Access Point IP
Address:
Subnet Mask:
Default Gateway:
Device Name:
Enable DHCP Server:
DHCP IP Address
Range Lease Time:
Select Static IP from the drop-down menu.
Enter the IP address of the access point. The
default IP address is 192.168.0.50. If you
change the IP address, once you click Apply,
you will need to enter the new IP address in
your browser to get back into the conguration
utility.
Enter the Subnet Mask assigned by your ISP.
Enter the Gateway assigned by your ISP.
Enter the Device Name of the AP. It is
recommended to change the Device Name if
there is more than one D-Link device within
the subnet. You can enter the device name
of the AP into your web browser to access
the instead of IP address for conguration.
If you are using the device name to connect,
ensure that your PC and your DAP-1360 are
on the same network.
Select this to enable the DHCP server if static IP address is selected.
Enter the starting and ending IP addresses for the DHCP server’s IP assignment. Enter the length of time for the IP address
lease.
Static IP
Select Static IP Address if all the Internet port’s IP information is provided to you by your ISP. You will need to enter in
the IP address, subnet mask, gateway address, and DNS address(es) provided to you by your ISP. Each IP address
entered in the elds must be in the appropriate IP form, which are four octets separated by a dot (x.x.x.x). The Access
point will not accept the IP address if it is not in this format.