User manual

50D-Link DAP-1360 User Manual
Section 3 - Configuration
PPPoE
Select PPPoE (Point-to-Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide
you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE
software from your computer. The software is no longer needed and will not work through the DAP-1360.
Username:
Password:
Service Name:
Reconnection Type:
Maximum Idle Time:
MTU Size:
Attain
DNS Automatically:
Set DNS Manually:
DNS Servers:
Clone MAC Address:
Enter your PPPoE user name.
Enter your PPPoE password and then retype
the password in the next box.
Enter the ISP Service Name (optional).
Select Always on, On demand, or Manual.
Enter a maximum idle time during which the
Internet connection is maintained during
inactivity.
You may need to change the MTU (Maximum
Transmission Unit) for optimal performance with
your specic ISP. The default MTU size is 1492.
Select this option if you want the DAP-1360 to
get the DNS (Domain Name System) server IP
address automatically.
Select this option if you want to manually enter
the DNS Server IP address(es). Fields to enter
the Primary and Secondary DNS server IP addresses will appear after you select this option.
Enter the Primary and Secondary DNS server IP address assigned by your ISP.
The default MAC address is set to the MAC address on the AP (Access Point). You can click the Clone Your PC’s MAC
Address button to replace the AP’s MAC address with the MAC address of your Ethernet card. It is not recommended
that you change the default MAC address unless required by your ISP.