User manual

43D-Link DAP-1360 User Manual
Section 3 - Configuration
Enable Wireless:
Wireless Mode:
Site Survey:
Wireless Network
Name:
Wireless Channel:
802.11 Mode:
Channel Width:
Transmission Rate:
Enable Hidden
Wireless:
Wireless Security
Mode:
WPS:
Check the box to enable the wireless function. If
you do not want to use wireless, uncheck the box
to disable all the wireless functions. You may also
set up a specic time range (schedule). Select a
schedule from the drop-down menu or click Add
New to create a new schedule.
Select Repeater from the drop-down menu.
Click Site Survey to display a list of wireless
networks in your area. You may select the wireless
access point to connect to.
Enter the SSID of the access point you want to repeat
the signal of. If you do not know for sure, click Site
Survey and select it from the list, if available.
The channel will automatically change to the channel
of the AP you are connected to.
Select the appropriate 802.11 mode based on the
wireless clients in your network. The drop-down
menu options are 802.11g Only, Mixed 802.11b/g,
802.11b Only, 802.11n Only, or Mixed 802.11b/g/n.
Select the appropriate channel width between 20MHz or Auto 20/40MHz from the drop-down menu.
Select the transmission rate. It is strongly suggested to use the Auto setting for optimal performance.
Check the box if you do not want the SSID to be broadcast by the DAP-1360. This prevents the SSID from being seen by site
survey utilities, so any wireless clients will have to be pre-congured with the SSID of the DAP-1360 in order to connect to it.
Select a wireless security setting. Options are None, WEP, WPA, or WPA2. See the Wireless Security section in this manual
for a detailed explanation of the wireless security options.
Select enable if you want to congure the DAP-1360 with Wi-Fi Protection setup.
Repeater Mode