User manual

47D-Link DAP-1360 User Manual
Section 3 - Conguration
Device Name:
LAN Connection Type:
IP Address:
Subnet Mask:
Default Gateway:
Enter the Device Name of the AP. It is
recommended to change the Device Name if
there is more than one D-Link device within the
subnet.Youcanenterthedevicenameofthe
AP into your web browser to access the instead
of IP address for conguration. If you are using
thedevicenametoconnect,ensurethatyour
PC and your DAP-1360 are on the same network.
Select Static IP from the drop-down menu.
Enter the IP address of the access point. The
default IP address is 192.168.0.50. If you change
theIPaddress,onceyouclick Apply, youwill
need to enter the new IP address in your browser
to get back into the conguration utility.
Enter the Subnet Mask assigned by your ISP.
EntertheGatewayassignedbyyourISP.
Static IP
SelectStaticIPAddressifalltheInternetport’sIPinformationisprovidedtoyoubyyourISP.YouwillneedtoenterintheIP
address,subnetmask,gatewayaddress,andDNSaddress(es)providedtoyoubyyourISP.EachIPaddressenteredintheelds
mustbeintheappropriateIPform,whicharefouroctetsseparatedbyadot(x.x.x.x).TheAccesspointwillnotaccepttheIP
address if it is not in this format.