Instructions

44D-Link DAP-1360 User Manual
Section 3 - Conguration
PPPoE
SelectPPPoE(Point-to-PointProtocoloverEthernet)ifyourISPusesaPPPoEconnection.YourISPwillprovideyouwitha
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through the DAP-1360.
Username:
Password:
Service Name:
Reconnection Type:
Maximum Idle Time:
MTU Size:
Attain
DNS Automatically:
Set DNS Manually:
DNS Servers:
Clone MAC Address:
Enter your PPPoE user name.
Enter your PPPoE password and then retype the
passwordinthenextbox.
Enter the ISP Service Name (optional).
Select Always on,On demand,orManual.
Enter a maximum idle time during which the
Internet connection is maintained during inactivity.
You may need to change the MTU (Maximum
Transmission Unit) for optimal performance with
yourspecicISP.Themaximum/defaultMTUsize
is 1492.
Select this option if you want the DAP-1360 to get
the DNS (Domain Name System) server IP address
automatically.
Select this option if you want to manually enter
the DNS Server IP address(es). Fields to enter the
Primary and Secondary DNS server IP addresses will appear after you select this option.
Enter the Primary and Secondary DNS server IP address assigned by your ISP.
ThedefaultMACaddressissettotheMACaddressontheAP(AccessPoint).YoucanclicktheClone Your PC’s MAC Address
button to replace the AP’s MAC address with the MAC address of your Ethernet card. It is not recommended that you change
the default MAC address unless required by your ISP.