Instructions

39D-Link DAP-1360 User Manual
Section 3 - Conguration
Enable Wireless:
Wireless Mode:
Wireless Network
Name:
802.11 Mode:
Wireless Channel:
Enable Auto
Channel Scan:
Channel Width:
Visibility Status:
Remote AP MAC:
Bridge Security:
Select this to turn the Wi-Fi module on and o. Use the
drop-downboxtoselectifyouwanttouseaschedule.
Click Add New to add or change a schedule.
Select Bridge from the drop-down menu.
The Wireless Network Name is a unique name that
identies a network. All devices on a network must share
the same wireless network name in order to communicate
on the network. If you decide to change the wireless
networknamefromthedefaultsetting,enteryournew
wireless network name in this eld.
Select the appropriate 802.11 mode based on the wireless
clients in your network. The drop-down menu options
are 802.11g Only, Mixed 802.11b/g, 802.11b Only,
802.11n Only,orMixed 802.11b/g/n.
All devices on the network must share the same channel.
The Auto Channel Scan setting can be selected to allow
the DAP-1360 to choose the channel with the least
amount of interference.
Select the appropriate channel width between 20MHz
or Auto20/40MHz from the drop-down menu.
Select the transmission rate. It is strongly suggested to use the Auto setting for optimal performance.
Enter the MAC addresses of the APs in your network that will serve as bridges to wirelessly connect multiple networks.
Select None to disable encryption to across the network. Select WEP 64-bit or WEP 128-bit to limit communication to only those
devices that share the same WEP settings. Select WPA-PSK or WPA2-PSK to secure your network using a password and dynamic key
changes (No RADIUS server required).
Bridge Mode
Note: The Bridge mode is not completely specied in the Wi-Fi or IEEE standards. This mode can work with other DAP-1360 units. Communication with
other APs (even other D-Link APs) is not guaranteed.