User manual

35D-Link DAP-1350 User Manual
Section 3 - Configuration
Save to Local
Hard Drive:
Upload from
Local Hard Drive:
Restore to
Factory Default:
Reboot the
Device:
Use this option to save the current access point
conguration settings to a le on the hard disk of
the computer you are using. Click the Save button.
You will then see a le dialog where you can select
a location and le name for the settings.
Use this option to load previously saved access
point conguration settings. Click Browse to nd a
previously saved conguration le. Then, click the
Upload Settings button to transfer those settings
to the access point.
This option will restore all conguration settings
back to the settings that were in effect at the time
the access point was shipped from the factory.
Any settings that have not been saved will be lost,
including any rules that you have created. If you
want to save the current access point conguration
settings, use the Save button above.
Note: Restoring the factory default settings
will not reset the Wi-Fi Protected Status to Not
Congured.
Click to reboot the access point.
System