User manual
27D-Link DAP-1320 User Manual
Section 3 - Web-based Conguration
Select the type of LAN connection. If you select Dynamic IP,
all the values below will already be set. If you select Static IP,
you need to enter the below values.
Enter the IP address.
Enter the subnet mask.
Enter the gateway address.
Enter the IP address of the primary DNS server.
Enter the IP address of the secondary DNS server.
My LAN
Connection
is:
IP Address:
Subnet Mask:
Gateway
Address:
Primary DNS
Server:
Secondary
DNS Server:
If you need to use a IPv4 provisioning mechanism for the
Repeater, congure the settings below.
If you need to use a IPv6 provisioning mechanism for the
Repeater, select the mechanism to use: Link-local only,
Static IPv6, and Autoconguration. Refer to below and the
next page for details on conguring the dierent security
modes.
If you selected Link-Local only, you will see the
following settings:
The IPv6 Link-Local Address is the IPv6 Address that you use
tto access the Web-based management interface.
LAN IPv6
Link-Local
Address: