User manual
10D-Link DAP-1320 User Manual
Section 2 - Conguration
One-Touch AP Conguration
The DAP-1320 supports One-Touch AP conguration using the WPS (Wi-Fi Protected Setup) button to connect to a wireless
router to extend the Wi-Fi network in your home, as well as for connecting devices to the DAP-1320’s extended wireless network.
Note: To use One-Touch AP Conguration to connect to a wireless router, please make sure the router features a WPS button.
1.
Plug the DAP-1320 into a wall outlet and wait until the
power LED is blinking amber.
2. Push the WPS button on the wireless Router, and
then push and hold the WPS button on the DAP-1320 for
about 5 seconds or until the green LED starts to ash. Please
allow up to two minutes for the process to nish.
Note: To connect devices to the DAP-1320, you just push the WPS button on the DAP-1320 for 1 second, then repeat the
process on the device. If the connection fails (amber LED still ashes), move your DAP-1320 closer to your wireless router and
repeat steps 1 and 2.
The LED will become solid green when the DAP-1320 has
connected successfully to the wireless router or AP. The DAP-1320
is then ready for you to share a Wi-Fi network with your PCs and
mobile devices by using the network name (SSID) and password
located on your Wi-Fi Conguration Card.
Outlet
Ethernet