User manual

DAP-1155 Wireless N 150 Access Point & Router
User Manual
Installation and Connection
Connecting to Web-based Interface
When you have configured your computer, you can access the web-based interface and configure
needed parameters (configure the wireless network, change the operating mode of the device,
specify the settings of the firewall, etc.).
1. Start a web browser (see the Before You Begin section, page 14).
2. In the address bar of the web browser, enter http://dlinkap/ or
http://192.168.0.50/ (the default IP address of the access point). Press the Enter
key.
Figure 17. Connecting to the web-based interface of the DAP-1155 device.
3. On the opened page, enter the username and password for the administrator account in the
Login and Password fields correspondingly (by default, the following username and
password are specified: admin, admin). Then click the Enter link.
Figure 18. The login page.
!
If the error “ The page cannot be displayed ” (or “ Unable to display the page ”/“ Could not
connect to remote server ”) occurs upon connecting to the web-based interface of the access
point, make sure that you have properly connected the access point to your computer.
Page 29 of 215