User manual

DAP-1155 Wireless N 150 Access Point & Router
User Manual
Configuring Device (Router Mode)
LAN
To configure the access point's local interface, proceed to the Net / LAN page.
Figure 119. Basic settings of the local interface.
If needed, edit the basic settings of the local interface.
Parameter Description
IP Address
The IP address of the access point in the local subnet. By default, the
following value is specified: 192.168.0.50.
Netmask
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
When needed settings are configured, click the Save button.
In the DHCP server section, you can configure the built-in DHCP server of the access point. In
the router mode, the DHCP server is enabled by default.
Figure 120. The section for configuring the DHCP server.
Parameter Description
Mode
An operating mode of the access point's DHCP server.
Enable: the access point assigns IP addresses to clients
automatically in accordance with the specified parameters. When
this value is selected, the DNS Relay, Start IP, End IP, and the
Lease time fields are displayed on the page.
Disable: the access point's DHCP server is disabled, clients' IP
addresses are assigned manually.
Relay: an external DHCP server is used to assign IP addresses to
clients. When this value is selected, the External DHCP server IP
field is displayed on the page.
Page 152 of 215