User manual

39D-Link DAP-1150 User Manual
Section 3 - Conguration
Set the transmit power of the antennas.
Beacons are packets sent by an Access Point to synchronize a wireless network.
Specify a value. 100 is the default setting and is recommended.
This value should remain at its default setting of 2346. If inconsistent data ow is
a problem, only a minor modication should be made.
The fragmentation threshold, which is specied in bytes, determines whether
packets will be fragmented. Packets exceeding the 2346 byte setting will be
fragmented before transmission. 2346 is the default setting.
(Delivery Trafc Indication Message) 1 is the default setting. A DTIM is a countdown
informing clients of the next window for listening to broadcast and multicast
messages.
Select Short or Long Preamble. The Preamble denes the length of the CRC block
(Cyclic Redundancy Check is a common technique for detecting data transmission
errors) for communication between the wireless AP and the roaming wireless
network adapters. Auto is the default setting. Note: High network trafc areas should use the shorter preamble type.
CTS (Clear To Send) is a function used to minimize collisions among wireless devices on a wireless local area network (LAN). CTS will make sure the wireless
network is clear before a wireless client attempts to send wireless data. Enabling CTS will add overhead and may lower wireless through put. None: CTS is typically
used in a pure 802.11g environment. If CTS is set to “None” in a mixed mode environment populated by 802.11b clients, wireless collisions may occur frequently.
Always: CTS will always be used to make sure the wireless LAN is clear before sending data. Auto: CTS will monitor the wireless network and
automatically decide whether to implement CTS based on the amount of trafc and collisions that occurs on the wireless network.
802.11n Only - Select only if all of your wireless clients are 802.11n.
Mixed 802.11n, 802.11b, and 802.11g - Select if you are using a mix of 802.11n, 11g, and 11b wireless clients.
Select if you are using both 802.11n and non-802.11n wireless devices.
Select if you are not using any 802.11n wireless clients. This is the default setting.
Check this box to reduce the guard interval time therefore increasing the data capacity. However, it’s less reliable and may create higher data
loss.
Transmit Power:
Beacon interval:
RTS Threshold:
Fragmentation:
DTIM Interval:
Preamble Type:
CTS Mode:
802.11 Mode:
Auto 20/40:
20MHz:
Short GI:
Advanced Wireless
This window allows you to change the behavior of the 802.11n wireless radio from the standard settings. Please be aware that
any changes to the factory default settings may adversely affect the behavior of your network.
NOTE: Some options are unavailabe in Repeater mode.