User manual

60D-Link D-ViewCam User Manual

Section 3 - Conﬁguration

Go to Preset Point

Turn to the preset location upon the motion triggering.

Step 1 - Select the Go to Preset Point action.

Step 2 - Select from the Preset Point field. When event is detected, the system will turn PT camera to the specified

preset location. Then, click /OK to activate this setup.

Note: Seconds before starting event action means the delayed time before executing the event action. If you prefer

NOT to start the event action immediately, you can set a wait time so that the action will start after the wait time has

expired.

Step 1

Step 2