User manual

42D-Link D-ViewCam User Manual

Section 3 - Conﬁguration

Step 1

Step 2

Step 3

Event Action List Table

Change Digital Output State

This setting will trigger the devices that connect to the system, such as alarm lights and sirens. When an event occurs,

youcanchangethedevicestatus(availablefordigitaloutputonly).Followthestepsbelowtocongurethedigitaloutput

state.

Step 1 - Select the action Change Digital Output State and set the digital output.

Step 2 - Change the output state to on or o.

Step 3 - Seconds before starting event action means the delayed time before the event action is executed. If you

prefer NOT to start the event action immediately, you can set a wait time so that the action will start after the

wait time has expired. Click /OK to activate the setting.