User`s manual

• Click OK to save the Autokey IKE VPN tunnel.
Example Main Office Autokey IKE VPN tunnel:
Adding internal and external addresses
The next step in configuring the VPN is to add the addresses of the networks that are to be connected using
the VPN tunnel. On each VPN gateway you must add two addresses:
• Internal address, the IP address of the network behind the VPN gateway
• External address, the IP address of the network behind the other VPN gateway
IPSec Autokey VPN addresses
shows the internal and external addresses required for the VPN in Example
VPN between two internal networks. In the example, both IP addresses are for internal networks.
IPSec Autokey VPN addresses
Description Main Office
Branch
Office
Internal Address
Address
Name
The name to assign to the internal network to be connected using the VPN.
The name can contain numbers (0-9) and upper and lower case letters (A-
Z, a-z), and the special characters - and _. Spaces and the @ character are
not allowed.
Main_Office Branch_Office
IP
address
192.168.1.0 192.168.2.0
Netmask
The IP address and netmask of the internal network.
255.255.255.0 255.255.255.0
External Address
Address
Name
The name to assign to the internal network to be connected to the opposite
end of the VPN tunnel.
Branch_Office Main_Office
IP
address
192.168.2.0 192.168.1.0
Netmask
The IP address and netmask of the internal network at the other end of the
VPN tunnel.
255.255.255.0 255.255.255.0
DFL-500 User’s Manual
45