User`s manual

Configuring the Transparent mode management IP address

• Login to the CLI if you are not already logged in.

• Set the IP address and netmask of the Management IP to the IP address and netmask that you recorded

in Transparent mode configuration information

. Enter:

set system manageip ip <IP Address> <Netmask>

Example

set system manageip ip 10.10.10.2 255.255.255.0

• Confirm that the address is correct. Enter:

get system manageip

The CLI lists Management IP address and netmask.

Configure the Transparent mode default gateway

• Login to the CLI if you are not already logged in.

• Add a default route set to the Default Gateway IP Address that you recorded in Transparent mode

configuration information. Enter:

set system manageip gateway <IP Address>

Example

set system manageip gateway 192.168.1.20

You have now completed the initial configuration of the DFL-500 and you can proceed to connect the

DFL-500 to your network using the information in Connecting the DFL-500 to your network

that follows.

Connecting the DFL-500 to your network

Once the initial configuration of the DFL-500 is complete, you can connect the DFL-500 between your internal

network and the Internet. The connection procedures are the same whether you are running in NAT mode or

Transparent mode.

There are two 10/100 BaseTX connectors on the DFL-500:

• Internal for connecting to your Internal network

• External for connecting to your public switch or router and the Internet

To connect the DFL-500:

• Connect the Internal interface to the hub or switch connected to your internal network.

• Connect the External Interface to the public switch or router provided by your Internet Service Provider.

DFL-500 User’s Manual