User's Manual
Table Of Contents
11D-Link DCS-4201 User Manual
Section 2: Installation
Connect the Ethernet Cable
Connect the included Ethernet cable to the network cable connector located on
the panel at the rear of the DCS-4201 and attach it to the network.
Attach the External Power Supply
Attach the external power supply to the DC Power receptor located on the rear
panel of the DCS-4201 and connect it to your wall outlet or power strip.
Note: If you choose to take advantage of the Power over Ethernet feature you
may unplug the power cable.
If you wish to set up your camera without using the Camera Setup Wizard, please follow these steps.
Installation
Hardware Installation