D-Link DMP-CD100 MP3 CD Player Rev: 10242000 1
TABLE OF CONTENTS SAFETY PRECAUTIONS......................................................1 MP3 FILE INFORMATION ...................................................3 POWER SUPPLY ....................................................................4 FEATURE LAYOUT ..............................................................6 LCD DISPLAY INDICATORS ...............................................7 PLAYING A CD......................................................................7 BASIC FEATURES .............
FCC INFORMATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
• • • • • • • • • • Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, pay particular attention to cords at plugs, convenience receptacles, and the point where they exit from the DMP-CD100. Never remove the enclosure. If the internal parts are touched accidentally, a serious electric shock might occur. If an abnormal smell or smoke is detected, immediately turn the power OFF and pull out the power cord.
MP3 FILE INFORMATION WHAT IS MP3? MP3 is the abbreviation of “MPEG 1 Audio Layer 3”. MPEG Audio is a compression specification that compresses the audio portion only. This audio compression method is used in DVD and Video CD, etc. The audio data has been compressed into about 1/10 the size of a normal audio file. SEQ UENCE OF PLAYING MP3 FILES MP3 files will be played in the sequence that the writing software had recorded.
POWER SUPPLY RECHARGEABLE NICKEL CADMIUM BATTERY INSTALLATION 1. Remove the battery compartment cover by sliding the cover away from the DMP-CD100. 2. Insert the rechargeable nickel-cadmium battery into the battery compartment. Be sure to observe the proper polarity (The + and - signs, as indicated inside the battery compartment). NOTE: Fully charge the rechargeable nickel - cadmium battery before using it for the first time. 3. Close the battery compartment. 4.
NOTE: It is always a good idea to let Nickel-Cadmium batteries run all the way down before charging them. When you do charge them, do so to their full potential and they will last longer and provide more power. ALKALINE BATTERY INSTALLATION Insert two AA batteries into the battery compartment on the bottom of the DMP-CD100. Be sure to observe the proper polarity (The “+” and “-“ signs, as indicated inside the battery compartment).
FEATURE LAYOUT 1. Disc Compartment Door 2. Electronic Shock Protection Button (ESP) 3. Stop Button 4. Program Button 5. Reverse skip/Search Button 6. Display Window 7. Play/Pause Button 8. Mode/ Repeat Button 9. Forward skip/Search Button 10. Track Digit Button (T.Digit) Rev: 10242000 11. DBBS switch 12. Door Open Switch 13. Hold switch 14. Volume knob 15. Line Out Jack 16. Headphone Jack 17. Power Indicator (Charging Indicator) 18. Batteries Compartment 19.
LCD DISPLAY INDICATORS PLAYING A CD 1. Connect the headphones to the headphone jack. 2. Set the volume knob to minimum. 3. Slide the door open switch to open the Disc compartment door. 4. Insert a disc (CD or CD-R) with the label side facing up. 5. Push down on the center of the front edge of the door to close securely. 6. Slide the hold switch to the “OFF” position. 7. Press the Play/Pause button. The total number of tracks and total playing time will be shown on the LCD display.
2. Press the forward skip/search button repeatedly to skip ahead to the beginning of other tracks. 3. Press the reverse skip/search button once to skip to the beginning of the current track. 4. Press the reverse skip/search button twice or more quickly to go back to previous tracks. SEARCH DURING PLAY MODE 1. Press and hold the skip/search button to quickly advance or reverse through the music at high speed. 2. Release the skip/search buttons to return to normal play. BASIC FEATURES PAUSE BUTTON 1.
REPEAT FEATURES REPEAT ONE PLAY 1. Press the REPEAT/MODE Button until the (REPEAT 1) Indicator appear on the display. 2. Select the desired track by pressing the FORWARD OR REVERSE SKIP / SEARCH Button. 3. The selected track will then begin playing through to its end at which point it will automatically return to the beginning of that track. REPEAT ALL PLAY 1. Press the REPEAT/MODE Button until the (REPEAT ALL) Indicator appear on the display. 2.
ADVANCED PLAYING MODES INTRO PLAY (INTRO) 1. Press the STOP button until the total track number and total plays time appears on the display. 2. Press the REPEAT/MODE button until the Intro Indicator (INTRO) flash on the display. 3. Press the PLAY / PAUSE button to start playing the Intro mode. 4. The disc will then begin playing the first ten seconds of all tracks once and then stops automatically. PROGRAM PLAY (PGM) 1.
1. Press the STOP button until the total track number and total playtime appear on the display. 2. Press the REPEAT/MODE button until you see the Random Indicator (RDM) flash on the display. 3. Press the PLAY / PAUSE button to start the Random play. 4. The DMP-CD100 will play tracks in a random sequence selected from all tracks on the disc. 5. When all disc tracks have been played, the DMP-CD100 will stop automatically. MP3 DISC - TRACK DIGIT SELECTION PLAY (T.DIGIT) 1. By pressing the T.
REMOVING THE DISC 1. After pressing the STOP button, wait for the disc to stop rotating before sliding the DOOR OPEN switch to remove the disc. 2. Hold the disc by the edge while slightly pressing on the center spindle, then lift from the edge to release and remove the disc. HANDLING COMPACT DISCS The DMP-CD100 is designed to play CD/CD-R bearing the correct identification logos. Other discs may not conform to the CD/CD-R standard and may not play properly.
TROUBLESHOOTING GUIDE Check the following guide for problem resolution. SYMPTOM CAUSE CD Player will not Hold Switch position is turn on “ON”. Dead or weak batteries. AC adaptor not connected properly. Disc will not play Disc inserted incorrectly. Defective compact disc. CD compartment not closed. Moisture has formed inside the CD deck. No sound from headphones Sound is skipping Rev: 10242000 Headphone plug not inserted properly. Volume control set to minimum. Weak batteries. Defective compact disc.
SPECIFICATIONS • • • • • • • • • • • • 1 Bit D/A Converter. Digital Filter 8 Times Over-sampling. Auto CD/MP-3 Detectable (reads CD/CD-R). 3 Spot Optical Pick-up. Up to 22 Selected Music Storing Ability. Up to 255 Music Selection of MP-3 Mode. Fast Track Selector in MP-3 Mode. Continue/ Intro/ Single Music/ Program/ Random Play Mode. Repeat Function. Bass Boost. Audio Line Out. Rechargeable Battery Function. Power Source : AC Adapter : Input 4.5V - 8V or Battery : DC 3V (AA1.5V x 2).
Offices AUSTRALIA CANADA CHILE CHINA DENMARK EGYPT FRANCE GERMANY INDIA ITALY JAPAN RUSSIA SINGAPORE S. AFRICA SWEDEN TAIWAN U.K. U.S.A. D-LINK AUSTRALASIA Unit 16, 390 Eastern Valley Way, Roseville, NSW 2069, Australia TEL: 61 -2-9417 -7100 FAX: 61 -2-9417 -1077 TOLL FREE: 1800 -177-100 (Australia), 0800-900900 (New Zealand) URL: www.dlink.com.au E-MAIL: support@dlink.com.au, info@dlink.com.
REGISTRATION CARD Print, type or use block letters. Your name: Mr./Ms _____________________________________________________________________________ Organization: ___ _____________________________________________ Dept.
