Building Networks for People Quick Installation Guide Nuclias Connect AC1200 Wave 2 Outdoor Access Point This document will guide you through the basic installation process for your new Nuclias Connect AC1200 Wave 2 Outdoor Access Point DAP-3666 Documentation also available via the D-Link Website
ENGLISH Before You Begin This chapter describes safety precautions and product information you have to know and check before installing DAP-3666. Professional Installation Required 1. Please seek assistance from a professional installer who is well trained in the RF installation and knowledgeable in the local regulations. 2. The DAP-3666 is distributed through distributor and system installer with professional technicians and will not be sold directly through retail store.
This installation guide provides basic instructions for installing the DAP-3666 Nuclias Connect AC1200 Wave 2 Outdoor Access Point on your network. For additional information about how to use the Access Point, please see the datasheet and user manual from the D-Link support website. Minimum System Requirements If any of the above items are missing, please contact your reseller. NOTE no PSU supplied. To power the units use an D-Link PoE switch, DPE-311GI or 802.3af PoE adapter.
ENGLISH Align the DAP-3666 with the mounting plate Once aligned, slide the device down so that the mounting plate securely locks into the DAP-3666 Align the DAP-3666 with the mounting plate Once aligned, slide the device down so that the mounting plate securely locks into the DAP-3666 2B: Mounting The DAP-3666 On A Wall Wall Mount Securely mount the base to the wall using wall plug and wall screw.
Pole Mount ENGLISH Wall Mount With the included hexagon socket spanner, tighten the mount screw until the DAP-3666 is secured. STEP 4: Connect Grounding Wire A grounding wire is recommended to protect your device from lightning strikes and the buildup of static electricity. Attach the other end of the grounding wire to either the wall or pole mount. Ensure that the wall or pole mount is connected to an electrical ground.
ENGLISH app from the App Store or Google Play by searching for Nuclias Connect or by scanning the QR code below. 2. Open the Nuclias Connect app and follow the onscreen instructions to discover and set up your device. Manual Configuration If you are not using Nuclias Connect, you may manually configure the DAP3666 using its web user interface (UI). Refer to the DAP-3666 User Manual for detailed configuration instructions.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ENGLISH Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
