User's Manual
Table Of Contents
- Product Overview
- Hardware Overview
- Basic Installation
- Web User Interface
- Wireless
- Wired Equivalent Privacy (WEP)
- Wi-Fi Protected Access (WPA / WPA2)
- Advanced Settings
- Wireless Resource Control
- VLAN List
- Port List
- Add/Edit VLAN
- PVID Settings
- AP Array Scan
- Configuration Settings
- Auto-RF
- Load Balance
- Authentication Settings-Web Redirection Only
- Authentication Settings- Username/Password
- Authentication Settings- Passcode
- Authentication Settings- Remote RADIUS
- Authentication Settings- LDAP
- Authentication Settings- POP3
- Login Page Upload
- IP Filter Settings
- MAC Bypass
- Dynamic Pool Settings
- Static Pool Setting
- Current IP Mapping List
- Wireless MAC ACL
- WLAN Partition
- Traffic Control
- Status
- Stats Page
- Log
- Maintenance Section
- Administration
- Configuration and System
- System Settings
- Help
- Knowledge Base
- Troubleshooting
- Technical Specifications
- Warranty
- Central WiFiManager
- Registration
91D-Link DAP-2682 User Manual
Appendix B - Troubleshooting
After you install your network adapter, by default, the TCP/IP settings
should be set to obtain an IP address from a DHCP server (i.e. wireless
router) automatically. To verify your IP address, please follow the steps
below.
Click on Start > Run. In the run box type cmd and click OK.
At the prompt, type ipcong and press Enter.
This will display the IP address, subnet mask, and the default gateway of
your adapter.
If the address is 0.0.0.0, check your adapter installation, security settings,
and the settings on your router. Some rewall software programs may
block a DHCP request on newly installed adapters.
How to check your IP address?
If you are connecting to a wireless network at a hotspot (e.g. hotel, coee shop, airport), please contact an employee or administrator to verify
their wireless network settings.