User's Manual
Table Of Contents
- Product Overview
- Hardware Overview
- Basic Installation
- Web User Interface
- Wireless
- Wired Equivalent Privacy (WEP)
- Wi-Fi Protected Access (WPA / WPA2)
- Advanced Settings
- Wireless Resource Control
- VLAN List
- Port List
- Add/Edit VLAN
- PVID Settings
- AP Array Scan
- Configuration Settings
- Auto-RF
- Load Balance
- Authentication Settings-Web Redirection Only
- Authentication Settings- Username/Password
- Authentication Settings- Passcode
- Authentication Settings- Remote RADIUS
- Authentication Settings- LDAP
- Authentication Settings- POP3
- Login Page Upload
- IP Filter Settings
- MAC Bypass
- Dynamic Pool Settings
- Static Pool Setting
- Current IP Mapping List
- Wireless MAC ACL
- WLAN Partition
- Traffic Control
- Status
- Stats Page
- Log
- Maintenance Section
- Administration
- Configuration and System
- System Settings
- Help
- Knowledge Base
- Troubleshooting
- Technical Specifications
- Warranty
- Central WiFiManager
- Registration
9D-Link DAP-2682 User Manual
Section 3 - Conguration
Web User Interface
The DAP-2682 supports an elaborate web user interface where the user can congure and monitor the device. Launch a web browser, type the IP
address of the access point (Default setting is http://192.168.0.50 or https://192.168.0.50) and then press Enter to login. Most of the congurable
settings are located in the left menu of the web GUI which contains section called Basic Settings, Advanced Settings and Status.