User's Manual
Table Of Contents
- Product Overview
- Hardware Overview
- Basic Installation
- Web User Interface
- Wireless
- Wired Equivalent Privacy (WEP)
- Wi-Fi Protected Access (WPA / WPA2)
- Advanced Settings
- Wireless Resource Control
- VLAN List
- Port List
- Add/Edit VLAN
- PVID Settings
- AP Array Scan
- Configuration Settings
- Auto-RF
- Load Balance
- Authentication Settings-Web Redirection Only
- Authentication Settings- Username/Password
- Authentication Settings- Passcode
- Authentication Settings- Remote RADIUS
- Authentication Settings- LDAP
- Authentication Settings- POP3
- Login Page Upload
- IP Filter Settings
- MAC Bypass
- Dynamic Pool Settings
- Static Pool Setting
- Current IP Mapping List
- Wireless MAC ACL
- WLAN Partition
- Traffic Control
- Status
- Stats Page
- Log
- Maintenance Section
- Administration
- Configuration and System
- System Settings
- Help
- Knowledge Base
- Troubleshooting
- Technical Specifications
- Warranty
- Central WiFiManager
- Registration
5D-Link DAP-2682 User Manual
Section 1 - Product Overview
Features
y Provide Ethernet to Wireless LAN bridge fully IEEE 802.3/u/ab compatible on the Ethernet side and fully interoperable with IEEE 802.11ac and b/g/n/a
compliant equipment
y Compatible with IEEE 802.11b high rate standard to provide wireless 11Mbps data rate
y Compatible with IEEE 802.11g higher speed standard to provide wireless 54Mbps data rate
y Compatible with IEEE 802.11a higher speed standard to provide wireless 54Mbps data rate
y Compatible with IEEE 802.11n higher speed standard to provide wireless 450Mbps data rate
y Compatible with 802.11ac higher speed standard to provide wireless 1300Mbps data rate
y Operation at 2.4~2.5GHz and 5.15~5.85GHz frequency band to meet worldwide regulations
y Supports IEEE 802.11ac and b/g/n/a wireless data encryption with 64/128-bit WEP for security
y Allows auto fallback data rate for reliability, optimized throughput and transmission range
y Web-based conguration and management
y Supports enhanced security – WPA-PSK and WPA2-PSK, RADIUS client, and Cipher negotiation
y Supports one 802.3at PoE port
y Supports two 10/100/1000M Ethernet ports
y AP Mode, WDS Mode, WDS with AP, and Wireless Client Mode
y Supports SNMP v1,v2,v3
y Support Trap server (SNMP v1, v2c)
y Support Central WiFiManager
y Support AP Array and AP Array Setup Tool
* Maximum wireless signal rate derived from IEEE Standard 802.11ac, 802.11g, 802.11a, and 802.11n specications. Actual data throughput will vary. Network conditions and environmental factors, including volume of
network trac, building materials and construction, and network overhead, lower actual data throughput rate. Environmental conditions will adversely aect wireless signal range.
**Please note that operating frequency ranges vary depending on the regulations of individual countries and jurisdictions. The DAP-2682 isn’t supported in the 5.25~5.35GHz and 5.47 ~ 5.725GHz frequency ranges in
some regions.
***Only compliant with 802.3at PoE switch and 802.3af standard can’t supply sucient power for DAP-2682