User's Manual
Table Of Contents
- Product Overview
- Hardware Overview
- Basic Installation
- Web User Interface
- Wireless
- Wired Equivalent Privacy (WEP)
- Wi-Fi Protected Access (WPA / WPA2)
- Advanced Settings
- Wireless Resource Control
- VLAN List
- Port List
- Add/Edit VLAN
- PVID Settings
- AP Array Scan
- Configuration Settings
- Auto-RF
- Load Balance
- Authentication Settings-Web Redirection Only
- Authentication Settings- Username/Password
- Authentication Settings- Passcode
- Authentication Settings- Remote RADIUS
- Authentication Settings- LDAP
- Authentication Settings- POP3
- Login Page Upload
- IP Filter Settings
- MAC Bypass
- Dynamic Pool Settings
- Static Pool Setting
- Current IP Mapping List
- Wireless MAC ACL
- WLAN Partition
- Traffic Control
- Status
- Stats Page
- Log
- Maintenance Section
- Administration
- Configuration and System
- System Settings
- Help
- Knowledge Base
- Troubleshooting
- Technical Specifications
- Warranty
- Central WiFiManager
- Registration
49D-Link DAP-2682 User Manual
Section 3 - Conguration
Static IP (Manual) is chosen here. Choose this
option if you do not have a DHCP server in
your network, or if you wish to assign a static
IP address to the DAP-2682. When Dynamic
IP (DHCP) is selected, the other elds here
will be grayed out. Please allow about 2
minutes for the DHCP client to be functional
once this selection is made.
Assign a static IP address that is within the
IP address range of your network.
Subnet Mask : Enter the subnet mask. All
devices in the network must share the same
subnet mask.
Enter the IP address of the gateway/router
in your network.
Enter a DNS server IP address. This is usually
the local IP address of your gateway/router.
Enter the username for the new account
here.
Enter the password for the new account here.
Get IP From :
IP Address :
Subnet Mask :
Gateway :
DNS :
Username:
Password: