User's Manual
Table Of Contents
- Product Overview
- Hardware Overview
- Basic Installation
- Web User Interface
- Wireless
- Wired Equivalent Privacy (WEP)
- Wi-Fi Protected Access (WPA / WPA2)
- Advanced Settings
- Wireless Resource Control
- VLAN List
- Port List
- Add/Edit VLAN
- PVID Settings
- AP Array Scan
- Configuration Settings
- Auto-RF
- Load Balance
- Authentication Settings-Web Redirection Only
- Authentication Settings- Username/Password
- Authentication Settings- Passcode
- Authentication Settings- Remote RADIUS
- Authentication Settings- LDAP
- Authentication Settings- POP3
- Login Page Upload
- IP Filter Settings
- MAC Bypass
- Dynamic Pool Settings
- Static Pool Setting
- Current IP Mapping List
- Wireless MAC ACL
- WLAN Partition
- Traffic Control
- Status
- Stats Page
- Log
- Maintenance Section
- Administration
- Administration
- Configuration and System
- System Settings
- Help
- Knowledge Base
- Troubleshooting
- Technical Specifications
- Antenna Pattern
- Warranty
- Federal Communication Commission Interference Statement
- Registration
D-Link DAP-2662 User Manual
7
Hardware Overview
LEDs Connections
2 Power Receptor Connect the supplied power adapter.
3 LAN (PoE) Port
Connect to a Power over Ethernet (PoE) switch or router via
an Ethernet cable.
4 Reset Button
Press and hold for ve seconds to reset the access point to
the factory default settings. Press and hold for one second
to reboot the access point.
1 Power/Status
Solid Red Indicates the access point has malfunctioned.
Blinking Red This LED will blink during boot-up.
Solid Green
Indicates that the DAP-2662 is working
properly.
Blinking Green
This light will blink green during data
transmission.
1
2
3
4