User's Manual
Table Of Contents
- Product Overview
- Hardware Overview
- Basic Installation
- Web User Interface
- Wireless
- Wired Equivalent Privacy (WEP)
- Wi-Fi Protected Access (WPA / WPA2)
- Advanced Settings
- Wireless Resource Control
- VLAN List
- Port List
- Add/Edit VLAN
- PVID Settings
- AP Array Scan
- Configuration Settings
- Auto-RF
- Load Balance
- Authentication Settings-Web Redirection Only
- Authentication Settings- Username/Password
- Authentication Settings- Passcode
- Authentication Settings- Remote RADIUS
- Authentication Settings- LDAP
- Authentication Settings- POP3
- Login Page Upload
- IP Filter Settings
- MAC Bypass
- Dynamic Pool Settings
- Static Pool Setting
- Current IP Mapping List
- Wireless MAC ACL
- WLAN Partition
- Traffic Control
- Status
- Stats Page
- Log
- Maintenance Section
- Administration
- Administration
- Configuration and System
- System Settings
- Help
- Knowledge Base
- Troubleshooting
- Technical Specifications
- Antenna Pattern
- Warranty
- Federal Communication Commission Interference Statement
- Registration
D-Link DAP-2662 User Manual
103
For detailed warranty information applicable to products purchased outside the United States, please contact the corresponding local D-Link oce.
This device and it’s antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance
with FCC multi-transmitter product procedures.
IC statement:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.
This device has been designed to operate with an antenna having a maximum gain of 5.1dBi. Antenna having a higher gain is strictly prohibited
per regulations of Industry Canada. The required antenna impedance is 50 ohms.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée
aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit
être installé et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.
Pour les produits disponibles aux États-Unis / Canada du marché, seul le canal 1 à 11 peuvent être exploités. Sélection d’autres canaux n’est pas possible.
This device and it’s antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance
with IC multi-transmitter product procedures.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre antenne ou transmetteur.
The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-channel mobile satellite
systems.
les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une
utilisation à l’intérieur an de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux.