Quick Installation Guide

Interface Connectors
ENGLISH
1 2 3
Figure 2: Bottom Connectors
#
Connector Description
1
PoE OUT
Gigabit RJ-45 port for data and
Power over Ethernet (PoE) power.
+ DATA
Supports a maximum of 12 W.
2 DATAGigabit RJ-45 port for data.
3
RESET
Press and hold for 20 seconds to
factory reset the device.
Table 2: Interface Description
1
Figure 3: Rear Connectors
# Connector
Description
1
LAN (PoE) Gigabit RJ-45 port for data and
PortPower over Ethernet (PoE).
Table 3: Interface Description
Installation
Using Power over Ethernet (PoE)
1. Use a standard Ethernet cable to connect
the LAN (PoE) port on the back of the
DAP-2622 to a PoE power source device
such as an 802.3at PoE switch.
Configuration
Using Nuclias Connect
The DAP-2622 is designed to be
managed through Nuclias Connect. Refer
to the Nuclias Connect Manual for
detailed configuration instructions.
Manual Configuration
Note: D-Link recommends manually
configuring the device before mounting it.
The management computer, DHCP server
and DAP-2622 must be in the same subnet.
Use one of the following methods to
access the web user interface:
Connecting through Ethernet
1. Use an Ethernet cable to connect the
DAP-2622 to the management computer,
or to the switch or router the management
computer is connected to.
2. Manage the access point from a
computer. Enter dap2622.local in
the address field of your browser.
3. Log in to the administration user interface.
The default login information is
Username: admin
Password: admin
2 DAP-2622 Quick Installation Guide