User's Manual
Table Of Contents
- Package Contents
- Installation
- Configuration
- Web-based Configuration Utility
- Wireless Setup Wizard
- Manual Configuration
- Advanced
- MAC Address Filter
- Wi-Fi Protected Setup
- User Limits
- Port Forwarding (WISP modes only)
- Port Filter (WISP modes only)
- DMZ (WISP modes only)
- Parental Control (WISP modes only)
- Advanced Network (WISP modes only)
- Maintenance
- Status
- Help
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Contacting Technical Support
- Warranty
40D-Link DAP-1360L User Manual
Section 3 - Conguration
Enable Wireless:
Wireless Mode:
Wireless Network
Name:
802.11 Mode:
Wireless Channel:
Enable Auto Scan:
Channel Width:
Visibility Status:
Remote AP MAC:
Bridge Security:
Select this to turn the Wi-Fi module on and o. Use the
drop-down box to select if you want to use a schedule.
Click Add New to add or change a schedule.
Select Bridge with AP from the drop-down menu.
The Wireless Network Name is a unique name that
identies a network. All devices on a network must
share the same wireless network name in order to
communicate on the network. If you decide to change
the wireless network name from the default setting,
enter your new wireless network name in this eld.
Select the appropriate 802.11 mode based on the
wireless clients in your network. The drop-down menu
options are 802.11g Only, Mixed 802.11b/g, 802.11b
Only, 802.11n Only, or Mixed 802.11b/g/n.
All devices on the network must share the same channel.
The Auto Channel Scan setting can be selected to allow
the DAP-1360L to choose the channel with the least
amount of interference.
Select the appropriate channel width between 20MHz
or Auto 20/40MHz from the drop-down menu.
Check the box if you do not want the SSID to be broadcast by the DAP-1360L. This prevents the SSID from being seen by site survey
utilities, so any wireless clients will have to be pre-congured with the SSID of the DAP-1360L in order to connect to it.
Enter the MAC addresses of the APs in your network that will serve as bridges to wirelessly connect multiple networks.
Select None to disable encryption to across the network. Select WEP 64-bits or WEP 128-bits to limit communication to only those
devices that share the same WEP settings. Select WPA-PSK or WPA2-PSK to secure your network using a password and dynamic key
changes (No RADIUS server required).
Bridge with AP Mode
Note: The Bridge with AP mode is not completely specied in the Wi-Fi or IEEE standards. This mode can work with other DAP-1360L units. Communication with other APs (even other
D-Link APs) is not guaranteed.