User's Manual
Table Of Contents
- Package Contents
- Installation
- Configuration
- Web-based Configuration Utility
- Wireless Setup Wizard
- Manual Configuration
- Advanced
- MAC Address Filter
- Wi-Fi Protected Setup
- User Limits
- Port Forwarding (WISP modes only)
- Port Filter (WISP modes only)
- DMZ (WISP modes only)
- Parental Control (WISP modes only)
- Advanced Network (WISP modes only)
- Maintenance
- Status
- Help
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Contacting Technical Support
- Warranty
17D-Link DAP-1360L User Manual
Section 2 - Installation
Bridge with AP Mode
The Bridge with AP mode is the same as the Bridge mode, but in this case, the DAP-1360L also acts as an AP. Clients with wireless
interfaces can wirelessly connect to the DAP-1360L and then connect to the other LAN that the DAP-1360L bridges to.
Note: The Bridge with AP mode is not specied in the Wi-Fi or IEEE standards. This mode will only work using two DAP-1360L units.
Communication with other APs (even other D-Link APs) is not guaranteed.
ComputerComputer
Computer Computer
DAP-1360L
(In Bridge Mode with AP Mode)
DAP-1360L
(In Bridge Mode with AP Mode)
LAN 1 LAN 2
Connecting Two Separate LANs Together Through Two DAP-1360L Units
(Wireless PCs Can Access the DAP-1360L Units)