User's Manual
Table Of Contents
- Product Overview
- Installation
- Configuration
- Access Point Mode
- Wireless Client Mode
- Router Mode
- Setup Wizard
- Internet Setup
- Wireless Setup Wizard
- Wireless Settings
- Network Settings
- USB Settings
- Virtual Server
- Application Rules
- MAC Address Filter
- Website Filters
- Firewall Settings
- Advanced Wireless Settings
- Wi-Fi Protected Setup
- UPnP Settings
- Guest Zone
- DMZ
- IPV6 Settings
- Administrator Settings
- Time Settings
- System Settings
- Firmware Update
- System Check
- Schedules
- Device Information
- Wireless
- Logs
- Statistics
- Internet Sessions
- IPv6
- Help
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Warranty
67D-Link DAP-1350 User Manual
Section 3 - Conguration
Dynamic IP (DHCP)
Select Dynamic IP(DHCP) to obtain IP Address information automatically from your ISP. Select this option if your ISP does not
give you any IP number to use. This option is commonly used for Cable modem services.
Host Name:
Use Unicasting:
DNS Server:
MTU:
MAC Address:
The Host Name is optional but may be required
by some ISPs.
Select if you are having problems obtaining an
IP address from your DHCP server.
Enter the Primary and Secondary DNS server
IP address assigned by your ISP.
You may need to change the MTU (Maximum
Transmission Unit) for optimal performance
with your specic ISP. The default MTU size is
1500.
The default MAC address is set to the Ethernet
MAC address your DAP-1350. You can click
the Clone Your PC’s MAC Address button to
replace the AP’s MAC address with the MAC
address of the PC that you used to register
with your ISP. It is not recommended that
you change the default MAC address unless
required by your ISP.