User's Manual

38D-Link DAP-1260L User Manual
Section 3 - Conguration
Enable Wireless:
Wireless Mode:
Site Survey:
Wireless Network
Name:
802.11 Mode:
Enable Auto
Channel Scan:
Wireless Channel:
Channel Width:
Visibility Status:
Wireless Security
Mode:
WPS:
Check the box to enable the wireless function. If you do
not want to use wireless, uncheck the box to disable all
the wireless functions. You may also set up a specic time
range (schedule). Select a schedule from the drop-down
menu or click
Add New to create a new schedule.
Select Repeater from the drop-down menu.
Click
Site Survey to display a list of wireless networks
in your area. You may select the wireless access point
to connect to.
Enter the SSID of the access point you want to repeat the
signal of. If you do not know for sure, click
Site Survey
and select it from the list, if available.
Select the appropriate 802.11 mode based on the
wireless clients in your network. The drop-down menu
options are
802.11n Only, Mixed 802.11n/g, or Mixed
802.11n/g/b.
The Auto Channel Scan setting can be selected to allow
the DAP-1260L to choose the channel with the least
amount of interference.
The channel will automatically change to the channel
of the AP you are connected to.
Select the appropriate channel width between 20MHz or
Auto 20/40MHz from the drop-down menu.
Check the box if you do not want the SSID to be broadcast by the DAP-1260L. This prevents the SSID from being seen by site survey
utilities, so any wireless clients will have to be pre-congured with the SSID of the DAP-1260L in order to connect to it.
Select a wireless security setting. Options are None, WEP, or WPA-Personal. See the Wireless Security section in this manual for a
detailed explanation of the wireless security options.
Check
Enable if you want to congure the DAP-1260L with Wi-Fi Protection setup.
Repeater Mode