User's Manual

37D-Link DAP-1260L User Manual
Section 3 - Conguration
Wireless Mode:
Site Survey:
Wireless Type:
Wireless Network
Name:
802.11 Mode:
Wireless Channel:
Enable Auto
Channel Scan:
Channel Width:
Visibility Status:
Wireless MAC
Clone:
Wireless Security
Mode:
WPS:
Select
Wireless Client Mode from the drop-down menu.
Click Site Survey to display a list of wireless networks in your
area. You may select the wireless access point to connect to.
Select Infrastructure if connecting to an access point or wireless
router, or select Ad-Hoc if connecting to another wireless client.
Enter the SSID of the access point you want to repeat the signal
of. If you do not know for sure, click
Site Survey and select it
from the list, if available.
Select the appropriate 802.11 mode based on the wireless
clients in your network. The drop-down menu options are
802.11n Only, Mixed 802.11n/g, or Mixed 802.11n/g/b.
The channel will automatically change to the channel of the AP
you are connected to.
The Auto Channel Scan setting can be selected to allow the
DAP-1260L to choose the channel with the least amount of
interference.
Select the appropriate channel width between 20MHz or Auto
20/40MHz from the drop-down menu.
Check the box if you do not want the SSID to be broadcast by the DAP-1260L. This prevents the SSID from being seen by site survey
utilities, so any wireless clients will have to be pre-congured with the SSID of the DAP-1260L in order to connect to it.
Check Enable if you can clone the wireless MAC address to connect the device.
Select a wireless security setting. Options are None, WEP, or WPA-Personal. See the Wireless Security section in this manual for a
detailed explanation of the wireless security options.
Check
Enable if you want to congure the DAP-1260L with Wi-Fi Protection setup.
Wireless Client Mode