Technical data

8.4 Special Settings 157
8.4 Special Settings
Special settings can be done in Expert Mode. Switch to expert
mode first, select the desired tab and the desired area.
Note: In Basic Mode only the necessary settings are shown.
For most users the settings made in basic mode will be
sufficient.
Do change the settings for DSL access only if your ISP request
these changes. Change the settings in small steps, one at a time,
and observe the effects of these changes.
Note: Improper values may effect the performance of the
HorstBox. Go back to the previous settings.
Restore the default settings if the HorstBox does not work properly
after an abortive configuration or if the admin’s passwort is lost.
To reset the HorstBox use the reset switch at the back of the
device.
• Press the reset switch for 10 seconds (see fig.2.2 Back panel
on p.21 for details).
• Release the switch.
• The HorstBox will reboot. This may take some minutes.
• Once the reboot is finished all settings are restored.
• To change the settings start the user interface in a browser,
default IP address: http://horstbox.
• Default user: admin
• Default password: admin
Note: When you restore the Default Settings, you will lose any
settings defined before. Take notes of all necessary set-
tings beforehand.