User's Guide Wireless Access Point DWL-6000AP

Using the Configuration Menu

Advanced > Filters > Wireless Access Settings

Select the Wireless Band (802.11a or 802.11b)

At the Access Control pull-down menu, select Disabled (the default setting,)

Accept or Reject.

Input up to 16 MAC Addresses in the Access Control List. The devices with the input

MAC Addresses will be accepted or rejected from the selected wireless band.

MAC Address (Media Access Control Address)

A unique hardware address that identifies a device on a network. It is assigned at

the factory and cannot be changed. Usually you will find this address on a sticker

on the device or on the packaging. (Please use the following format when entering

the MAC address- xx:xx:xx:xx:xx:xx)

Fragment Length: This value should remain at its default setting of 2346. If you

experience a high packet error rate, you may slightly increase your Fragmentation

Threshold within the value range of 256 to 2346. Setting the Fragmentation

Threshold too low may result in poor performance.

RTS Length: This value should remain at its default setting of 2346. If you encounter

inconsistent data flow, only minor modifications to the value range between 256 and

2346 are recommended.

RTS Length: This value should remain at its default setting of 2346. If you encounter

inconsistent data flow, only minor modifications to the value range between 256 and

2346 are recommended.

Transmit Power: Choose Full, 1/2, 1/8, or minimum Power. You may wish to limit

the distance of the signal for security purposes.