Installation guide

Ad-Hoc Channel:

All devices in the Ad-Hoc network

must be set to the same channel

Click Apply if you have made any changes

Data Packet Parameter:

Set the Fragmentation Threshold and the RTS Threshold. Please see below.

Proﬁle IP Settings:

You can Enable or Disable

the IP Settings portion of

your proﬁle here. If you

select Disable you will need

to conﬁgure the IP Address

information each time you

connect to a network. If

you select Enable you

will maintain the same IP

Address information each

time you connect to a

network.

Select Enable or Disable

Launch Utility on Startup:

Power Mode:

Disable -this default setting consumes the most power

Enable - this setting consumes the least power

Fragmentation Threshold:

This value should remain at its default setting of 2432. If you experience a high

packet error rate, you may slightly increase your Fragmentation Threshold within the

value range of 256 to 2432. Setting the Fragmentation Threshold too low may result

in poor performance.

This value should remain at its default setting of 2432. If inconsistent data ﬂow is a

problem, only a minor modiﬁcation should be made.

RTS Threshold:

Using the Conﬁguration Utility (continued)

Advanced