Specifications

Using the Configuration Menu

Advanced > IP Filter

Disabled IP Filter-

Select this option if you do not want to use IP filters.

Schedule-

IP Address- Enter the IP address range of the computers that you want the

policy to apply to. If it is only a single computer that you want

the policy applied to, then enter the IP address of the computer

in the Start Source IP and leave the End Source IP blank.

Use IP (Internet Protocol) filters to allow or deny computers access to the Internet based

on their IP address.

Port Range-

Enter in the port range of the TCP/UDP ports that you want the

policy to apply to. If it is only a single port that you want the

policy applied to, then enter the port number in the Start Port

field and leave the End Port field blank. If you want to use all the

ports, you can leave the port range empty.

Enabled or Disabled- Click Enabled to apply the filter policy or click Disabled to

enter an inactive filter policy. (You can reactivate the policy

later.)

Select Always, or choose From and enter the time period dur-

ing which the IP filter policy will be in effect.

Protocol-

Select the protocol the IP filter will use.