Quick Install Guide Wireless N /Wired PTZ H.264 Network Camera This document will guide you through the basic installation process for your new D-Link Network Camera.
ENGLISH DCS-5605/5635 Quick Install Guide This installation guide provides basic instructions for installing the DCS-5605/5635 Network Camera on your network. For additional information about how to use the camera, please refer to the User Manual which is located on the CD or from the D-Link support website. Installation Steps 1. Verify the package contents against the list below 2. Hardware Overview 3. Hardware Installation 4.
ENGLISH Hardware Overview Rear Panel 1 WPS 9 2 12V 2A 3 ETHERNET 4 5 LINE/VIDEO OUT MIC RESET 6 7 8 9 1 Micro SD Port Insert a Micro SD memory card to save data from the camera. 2 WPS (DCS-5635 Only) Press the WPS button to automatically connec t to a WPS-enabled wireless router or access point and establish connectivity. 3 Power Receptor Plug in the supplied power adapter to an outlet. 4 Ethernet Port Connect an Ethernet cable to a router, switch, or computer.
ENGLISH Hardware Overview Front Panel 1 4 4 2 3 1 WPS/Link LED The WPS LED will blink blue when initializing a connection, and illuminate with solid blue once the connection has been established (DCS-5635 only). The Link LED will illuminate green once a connection has been established. 2 Microphone The built-in microphone can be used to capture audio from sources nearby the camera. 3 Power LED The Power LED will illuminate red when the camera is receiving power.
Basic Connection Connect the camera to your switch or router via Ethernet cable and then connect the supplied power cable from the camera to a power outlet. ENGLISH Hardware Installation Note: Once power has been established, the Power LED will turn red. When the device has obtained an IP address and is accessible, the Link LED will turn green.
ENGLISH Configuration with Wizard Configuration Insert the DCS-5605/5635 CD into your computer's CD-ROM drive to begin the installation. If the Autorun function on your computer is disabled, or if the D-Link Launcher fails to start automatically, click Start > Run. Type D:\autorun.exe, where D: represents the drive letter of your CD-ROM drive. 1. Click Installation Wizard to begin the installation. Install the Setup Wizard SE and execute the program. 2.
Configuration with Wizard ENGLISH Viewing Camera via Web Browser 1. Click on the D-Link Setup Wizard SE icon that was created in your Windows Start menu. Go to Start > D-Link > Setup Wizard SE. 2. Select the camera and click the Link button to access the web configuration. The Setup Wizard will automatically open your web browser to the IP address of the camera. 3. Enter admin as the default username and leave the password blank. Click OK to continue. 4.
Technical Support D-Link’s website contains the latest user documentation and software updates for D-Link products. U.S. and Canadian customers can contact D-Link Technical Support through our website or by phone. United States Telephone (877) 354-6555 World Wide Web http://support.dlink.com Canada Telephone (877) 354-6560 World Wide Web http://support.dlink.ca Version 1.1 October 11, 2010 6DCS5635Q.02G Copyright ©2010 D-Link Corporation/D-Link Systems, Inc. All rights reserved.
