Specifications

DGS-3212SR Stackable Gigabit Layer 2 Switch
Port Configuration
To configure basic port settings such as port speed, duplex, and learning state, use the Port Configuration window.
Click the Port Configuration link in the Configuration folder:
Figure 4- 4. Port Configuration window
To configure Switch ports:
• Choose the Unit from the pull-down menu.
• Choose the port or sequential range of ports using the From…To… port pull-down menus.
• Use the remaining pull-down menus to configure the parameters described in the table below.
The configurable parameters for ports include the following:
Parameter Description
Unit
Select the Switch in the Switch stack to be configured using the pull-down menu. 15
a switch in standalone mode.
From and To Select a port or range of ports to be configured
State <Enabled> Toggle the State field to either enable or disable a given port.
Speed/Duplex <Auto> Toggle the Speed/Duplex field to either select the speed and duplex/half-duplex
state of the port. Auto denotes auto-negotiation between 10 and 100 Mbps devices,
in full- or half-duplex. The Auto setting allows the port to automatically determine the
fastest settings the device the port is connected to can handle, and then to use
those settings. The other options are Auto, 10M/Half, 10M/Full, 100M/Half and
100M/Ful
l
, 1000M/Full
_
M and 1000M/Full
_S
. There is no automatic ad
j
ustment of
43