Specifications

DGS-3212SR Stackable Gigabit Layer 2 Switch
The Stack Information Table displays the read-only information listed in the table on the next page.
The current order in the Switch stack is also displayed on the front panel of each slave Switch, under the STACK NO.
heading. The Stack ID LED display on the front panel of the DGS-3212SR will always display an F (15 in hex), regardless
of whether the DGS-3212SR is the master Switch in a Switch stack or in standalone mode.
Below is an example of the Stack Mode Setup window with stacking mode enabled on Port 2.
Figure 7- 2. Stack Mode Setup (stacking enabled) window
Variables in this window are described below:
Parameter Description
ID
Displays the Switch’s order in the stack. The Switch with a unit id of 1 is the master
Switch.
MAC Address
Displays the unique address of the Switch assigned by the factory.
Port Range
Displays the total number of ports on the Switch. Note that the stacking port is
included in the total count.
Mode
Displays the method used to determine the stacking order of the Switches in the
Switch stack.
Version
Displays the version number of the stacking firmware.
RPS Status
Displays the status of an optional Redundant Power Supply.
Model Name
Displays the model name of the corresponding Switch in a stack.
When the stacked group is connected and properly configured, the virtual stack appears in the upper right-hand corner of
the web page.
155