User`s manual

CM-030PMCL-RH
34
10.2. Specification table
Specifications
CM-030PMCL-RH
Scanning system
Progressive scan
Frame rate full frame
120.491 frames/sec. Progressive
(511 lines/frame)
Pixel clock
58 MHz
Line frequency
61.571 kHz
(942 pixel clock/line)
CCD sensor
1/3” Monochrome ICX424ALB
Sensing area
6.4 (h) x 4.8 (v) mm
Cell size
4.65 (h) x 4.65(v) m
Active pixels
659 (h) x 494 (v)
Pixels in video output. Full
2/3 partial
1/2 partial
1/4 partial
1/8 partial
659 (h) x 494 (v) 120.491 fps. H = 61.571 kHz
659 (h) x 328 (v) 172.95 fps H= 61.571 kHz
659 (h) x 246 (v) 216.80 fps. H = 61.571 kHz
659 (h) x 122 (v) 349.83 fps. H = 61.571 kHz
659 (h) x 60 (v) 504.72 fps. H = 61.571 kHz
Vertical Binning
1/2 Binning 659(h) x 247(v) 193.88 fps
(Note: Binning and Partial scan can not be used at the same time)
Sensitivity on sensor (minimum)
0.3 Lux (Max. gain, Shutter OFF, 50% video)
S/N ratio
More than 50 dB (0dB gain)
Digital Video output
8 or 10 bit in Camera Link
Gain
Manual -3 to +12 dB
Gamma
1.0
Synchronization
Int. X-tal.
Trigger input.
Via Camera Link
EEN output
4 V from 75  source
Trigger modes
Pre-Select , Pulse Width and EPS with Smearless
Accumulation
LVAL synchronous or asynchronous automatic selection
Preset Shutter speed
OFF(1/120) , 9 fixed steps 1/250 to 1/30,000 second
Programmable exposure
2 L to 511 L (32.48 s to 8.299 ms)
Pulse width control
2 L to 240 frames ( 32.48µs to 2 seconds )
Readout modes
Full, Partial scan.(2/3, 1/2, 1/4, 1/8) V Binning
Control interface
Camera Link serial
Functions controlled by RS 232C
Shutter, Trigger, Scanning, Read out, Polarity, Black level, Gain,
Operating temperature
-5C to +45C
Humidity
20 – 90% non-condensing
Storage temp/humidity
-25C to +60C/20% to 90% non-condensing
Vibration
10G (20Hz to 200Hz, XYZ)
Shock
70G
Regulatory
CE (EN61000-6-2 and EN61000-6-3), FCC part 15 class B, RoHS, WEEE
Power
12V DC  10%. <0.3A ( Normal Operation )
Lens mount
φ17mm Exclusive mount
Dimensions
Head φ17 x 46mm ( φ x D ) with 2m cable
CCU 44 x 29 x 66 mm (H x W x D)
Weight
Head with 2m cable 120g, CCU 120g
Note: Above specifications are subject to change without notice
Note: Approximately 30 minutes pre heat required in order to meet specifications.